MYPIN TA4 MANUAL DOWNLOAD

MYPIN TA4 PID Controller, The MYPIN TA4 PID is one of the better controllers from China. Here is a copy of the actual instructions that ship with the controller . JConn Inv. PID Controller Instruction Manual This information is specific to the Mypin TA4 based controller sold by JConn Inv. but it should work for most TA4. Anyway, the manual did not come with the MYPIN PID. Does anyone have a link to the MYPIN PID manual? Manual for Mypin TA4.

Author: Goltishicage Nerg
Country: Japan
Language: English (Spanish)
Genre: Software
Published (Last): 18 December 2011
Pages: 79
PDF File Size: 9.96 Mb
ePub File Size: 14.9 Mb
ISBN: 115-7-53521-998-4
Downloads: 46693
Price: Free* [*Free Regsitration Required]
Uploader: Maran

You need to step through what it mypin ta4 manual set for now and make sure it matches what Mypin ta4 manual sent you. Apr 9, 4. Good luck with you smoking. You can put a few bricks on the rack of the smoker to simulate the meat as the bricks will soak up some of the heat similar to the way meat will.

Mypin TA4 user manual | – Beer, Wine, Mead, & Cider Brewing Discussion Community.

It’s in the manual ,ypin referenced above. Basically yours was doing the same thing? Let the PID adjust and hold the water at mash temperature for a normal mash cycle – for most of mypin ta4 manual that’s 1 hour 6. Set the PID temperature to your normal mash temperature 5. ,anual have mypin ta4 manual choices. Fellas, good news since turning that p value to off I’m able to get the pid and ssr to communicate properly.

TOP Related Posts  HC4060 DATASHEET PDF DOWNLOAD

Again, the manual has no information on how to use the controller. You should not need mypin ta4 manual auto tune your PID again inless your batch size changes or your brew area temperature drasticly changes.

Thanks fellas for the information, yes it is coming together a little more and more here and there l. Hard to follow the words, for me at least.

MyPin TA4 set-up

mypjn Press and hold “set” button for 3 seconds. It will fire the SSR heater when the actual temp falls below the set temp by the value set in the “hys” parameter mine is 3 degrees and turn off when the temp hits set temp.

Other than that did the wiring seem to match what you had? No, create an account now. Let me know if you have any questions about this. Mypin autotuning is covered in my assembly manual. Apr 9, 5. mypin ta4 manual

TOP Related Posts  THE NAMO STORY A POLITICAL LIFE EBOOK DOWNLOAD

Ta4 Wiring Diagram

mypin ta4 manual Press “set” until “HYS” 6. I don’t know about the other kind. Here is the completed switch. Press “set” to lock in. A diagram of the wiring would be better.

Mypin TA4 user manual

Apr 9, 1. Tardis have you done this with your mypin also looking for a way to verify he probe is caliberated and reading properly.

Brandon, I just received your PM and sent you a reply. You should always auto tune a new controller because auto-tuning sets the best parameters based on your personal set-up. Best to check this link as well: That is why you will see some pulsing of mypin ta4 manual power as a properly tuned PID works.

If you were mypin ta4 manual stick it into a glass of room temp water, it would drop fairly rapidly. What dictates how far that probe and pid reading is off? Yes, my password is: